Wall Paneling Tips
Walls get ugly in a variety of ways. Over time, they may begin to crack. The paint may peel. Someone may cover them with hideous wallpaper or coat them with a thick layer of paint to create a textured effect.
You can deal with problems like these in three ways:
–You can try to remove them.
–You can repair them.
–You can simply cover them up with a new wall.
In many cases, the cover-up is the easiest route to take, especially if you do the job with pre-finished paneling. You could also use drywall, but if you do, you’ll have to tape all your joints, apply two or three coats of drywall compound, sand and then apply a couple of coats of paint.
That adds up to a lot of work. If you choose paneling, it’s pretty much a matter of putting it up and getting on with your life. Actually, it’s not quite that simple. Before you can panel, you’ll have to remove all the trim – moldings, casings, etc. – on the old wall. After the paneling is up, you replace the trim, either reusing the old trim, or starting over with new.
Your problems, if any, will no doubt center on the trim, especially at window and door openings. Take a look at the sketch at right to see what I mean. When your walls were originally built, the drywall or plaster was installed flush with the edges of door and window jambs.
Then a piece of trim called casing was installed over the joint between the wall and the jamb, covering it up and creating a neat finished look. But when you apply paneling over an existing wall, you increase the thickness of the wall, and its surface no longer sits flush with the edge of the door and window jambs.
Solution?
One is to rip a strip of pine to the thickness of the paneling and use it as a filler strip to bring the jambs out flush with the surface of the new paneling . This works quite nicely if your jambs are painted. Just fasten the filler strips in place with brads and glue, fill any nail holes and paint both jamb and filler strip. The strip will look like part of the original jamb and you are ready to reinstall your casing.
This approach doesn’t work quite so neatly if the jambs are finished naturally . . . with varnish and possibly a stain. The reason? It’s difficult to match the color of the filler strip to the jamb. In this case, you might consider a different approach. Instead of putting a filler strip on the jamb, rabbet the back of the casing, cutting it so it wraps around the edge of the new paneling. This is more work, and it will require a table saw or a jointer, but it will provide an invisible solution to your problem.
Technorati tags: paneling trim strip filler jamb paint
Related posts:
- How Do I Move Electrical Wiring Safely Out of the Way So I Can Install a in Wall Doggie Door? Is there anything that has to be done to safely...
- When Should Floor Kitchen Cabinets Be Screwed to the Wall if at All? Should kitchen floor cabinets be screwed to the wall when...
- Suncast C2800G Utility 2 Door Wall Cabinet Durable resin construction Easy snap together assembly 1 adjustable...
- Frigidaire FAH106S2T Through-the-Wall 10,000 BTU Air Conditioner Through the wall installation 10,000 BTU cooling capacity Cools...
- Kitchen Cabinet Assembly 101: Wall Cabinets With a Door In this video one of our local contractors shows...
Tags: drywall compound, paint, paneling, plaster, wall, wall paneling, wallpaper